What is a steel straightening machine? This is a kind of mechanical equipment for steel bar processing. In work, it can straighten and cut steel bars with a diameter of less than 14 mm, and can remove rust. The straightening machine is mainly driven by the motor through the belt to increase the speed of the transmission, and can make the straightening cylinder rotate at a high speed. The steel bar passing through the straightening cylinder is straightened, and the straightening die can remove the rust on the surface of the steel bar. In order to ensure the quality of work, special attention is required during installation. So let Fang Rong Precision Machinery Co., Ltd. talk about the details of straightening machine installation for you today.

(1) When the straightener is installed, it should be on a relatively flat foundation, and some soft pads should be placed on the foundation to prevent the machine from vibrating with the ground at high speed.

(2) Connect the main unit of the steel bar straightening machine and the slide rail to the same straight line until it is the smoothest.

(3) Sturdy slideway limit lock.

(4) Straighten the steel bar straightening machine, bend slowly, increase the angle of the middle three blocks, and the angle of bean grains can be reduced.

(5) The punch head should be turned down by hand to see if it is engaged with the cutting assembly. If it is not engaged, the height of the slide bracket pulley can be adjusted.

(6) The upper motor should be consistent with the tip of the cut-off line wheel. Connect the slide spring.